Measurement of depths

Simultaneous gauging of diameter and detecting of NO-Go-gauges– TD-gauge +

TD-Gauge+ DIGITAL with radio module MDU-OPTO-S
TD-Gauge+ DIGITAL with radio module MDU-OPTO-S
TD-Gauge+ DIGITAL
TD-Gauge+ DIGITAL
TD-Gauge+ (analogue version)
TD-Gauge+ (analogue version)

For the simultaneous gauging of thread or bore depth and detecting of nogo gauges

Two versions are available: the analogue TD-Gauge+ and the digital TD-Gauge+ DIGITAL.

 

  • Universal system: DIN-gauges of all manufacturers can be used (DIN cone 1:50)

    • Thread gauges: M2.5 to M18 (DIN 2282 and DIN 2284)
    • Cylinder Plug gauges: Ø 2.0 to 18.0 mm (DIN 2248 and DIN 2249)

  • Reading scale is always visible
  • Universal setting master available
  • Special features like depth stop, air- and dirt-groove or extensions on request
  • Special features of the digital versions TD-Gauge+ DIGITAL:

    • LCD display with a resolution of 0.01 mm / 0.0005 Inch and preset

  • Optional transfer of measured values via DIAWIRELESS or via cable by OPTO-RS232 interface
  • Switch mm / Inch
  • Preset-Funktion
  • Special features of the analogue version TD-Gauge+:

    • Possible reading accuracy 0.05 mm
    • Pre- and post-decimal point places are readable at a glance (vernier)

Cylinder Plug Gauge (GO)
Cylinder Plug Gauge (GO)
Thread Plug (NOGO)
Thread Plug (NOGO)
Thread Plug (GO)
Thread Plug (GO)
Display of analogue TD-Gauge+ with Nonius
Display of analogue TD-Gauge+ with Nonius
Industrie 4.0

Downloads

TD-Gauge+ data sheet
TD-Gauge+digital data sheet
TD-Gauge+digital data sheet – ANSI